Language
Author: Smartweigh–Multihead Weighter
If you are using the multihead weigher and suddenly stop working one day, don't panic, calm down. Today, Zhongshan Smart weigh editor will share with you what to do if the multihead weigher fails and how to maintain it. When there is a problem with the multihead weigher, we must first check the problem. Before checking the fault, we must first confirm the following items: 1. Whether the correct operation is carried out according to the instructions. 2. Whether there is poor contact in the wiring part.
3. Is there any disconnection or disconnection of wires and wiring. 4. Whether the screws and parts are falling off or loose. 5. Whether a part of the equipment or parts are burnt, abnormally heated, deformed, etc.
6. Whether there is rust or dirt that can cause obstacles. The general multihead weigher will not run out of these problems, as long as we find the corresponding problems and solve them. So how do we maintain the multihead weigher in daily life? Maintenance of multihead weigher The multihead weigher is designed for materials with powdery and poor fluidity. It adopts a floor-standing structure, with a small structure and easy installation.
It has the characteristics of high weighing accuracy, simple and convenient installation and operation, strong reliability and complete functions, and can be widely used in flour, feed, bran, metallurgy, medicine, petrochemical, non-metallic minerals, fine chemicals, inorganic salts, Non-viscous bulk powder materials industry such as rubber, leather, fertilizer, etc. For this high-precision electronic product, we also need to do a good job of maintaining it. If you are not very clear on what to do, we will continue to look down. Before running the multihead weigher, please check the following: 1. Make sure that the front and rear conveyor belts are not in contact with the contact parts.
2. Set the parameters to confirm whether the standard value, upper limit and lower limit are set correctly. 3. The measurement accuracy is to convey the same measurement product more than 10 times from the auxiliary conveyor belt, and confirm whether the fluctuation is large. 4. The confirmation of the detection range only transmits the main product, and then the test piece is conveyed on the main product (unqualified products are transmitted when there is no test piece), and confirm separately“do not detect”,“detect”.
5. The removal action confirms the correct removal of normal products, overweight products and underweight products. After using the multihead weigher, clean up: 1. Clean the garbage around the scale. 2. Clean the dirt of the whole equipment.
Carry out the following inspections once a month: 1. Remove the conveyor belt from the conveyor belt and confirm whether the end face is cracked. 2. Make sure that the motor, roller and conveyor belt are in the running state of the conveyor belt, there is no abnormal noise, and the conveyor belt has no offset phenomenon.
Author: Smartweigh–Multihead Weighter Manufacturers
Author: Smartweigh–Linear Weighter
Author: Smartweigh–Linear Weigher Packing Machine
Author: Smartweigh–Multihead Weighter Packing Machine
Author: Smartweigh–Tray Denester
Author: Smartweigh–Clamshell Packing Machine
Author: Smartweigh–Combination Weighter
Author: Smartweigh–Doypack Packing Machine
Author: Smartweigh–Premade Bag Packing Machine
Author: Smartweigh–Rotary Packing Machine
Author: Smartweigh–Vertical Packaging Machine
Author: Smartweigh–VFFS Packing Machine
Copyright © Guangdong Smartweigh Packaging Machinery Co., Ltd. | All Rights Reserved
