Language
Maintenance of the pellet packaging machine is essential for long-term use. Machine parts lubrication 1. The box part of the machine is equipped with an oil meter. You should refuel it all at once before starting up. It can be added in the middle according to the temperature rise and operating conditions of each bearing. 2. The worm gear box must store oil for a long time. The oil level of the worm gear is such that all the worm gear invades the oil. If it is used frequently, the oil must be replaced every three months. There is an oil plug at the bottom for draining the oil. 3. When refueling the machine, don't let the oil spill out of the cup, let alone flow around the machine and on the ground. Because oil easily pollutes materials and affects product quality. Maintenance instructions 1. Check the machine parts regularly, once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other movable parts are flexible and worn. If any defects are found, they should be repaired in time and should not be used reluctantly. 2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body. 3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it, ready for the next use. 4. If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth canopy. Precautions 1. Before starting each time, check and observe whether there are any abnormalities around the machine; 2. When the machine is in operation, it is strictly forbidden to approach or touch the moving parts with your body, hands and head! 3. When the machine is in operation, it is strictly forbidden to extend your hands and tools into the sealing tool holder! 4. When the machine is working normally, it is strictly forbidden to switch the operating buttons frequently, and it is strictly forbidden to frequently change the parameter setting value; 5. It is strictly forbidden to run at super high speed for a long time; 6. It is forbidden for two or more colleagues to operate the various switch buttons and mechanisms of the machine; maintenance The power should be turned off during maintenance and repair; when multiple people are debugging and repairing the machine at the same time, they should communicate with each other and signal to prevent accidents caused by incoordination.
Copyright © Guangdong Smartweigh Packaging Machinery Co., Ltd. | All Rights Reserved