Failure Analysis of powder automatic packaging machine

It is also reasonable that the powder full-automatic packaging machine fails under long-term work, so the operator needs to do some understanding of these failures in order to better handle the emergency failure, the following are the common faults of the powder automatic packaging machine and the solutions: 1. The powder automatic packaging machine has a large deviation in the bag cutting position during operation, and the gap between the color code is too large, the color code locates the fault and the photoelectric tracking compensation is out of control. In this case, the position of the photoelectric switch can be readjusted first. If not, the shaper can be cleaned and the packaging material can be inserted into the plate, adjust the position of the guide board so that the light spot coincides with the middle of the color code. 2. It is also a common fault that the paper supply motor of the powder automatic packaging machine is stuck or not turned or is not controlled during the packaging process. First check whether the paper supply control rod is stuck and whether the starting capacitor is damaged, if there is any problem with the safety tube, then replace it according to the inspection result. 3. The sealing of the packaging container is not strict. This phenomenon will not only waste materials, but also pollute the equipment of the powder automatic packaging machine and the workshop environment because the materials are all powder and easy to spread. In this case, it is necessary to check whether the packaging container meets the relevant regulations, remove the fake packaging container, and then try to adjust the sealing pressure and increase the heat sealing temperature. 4. The powder automatic packaging machine does not pull the bag, and the bag motor drops the chain. The cause of this kind of failure is nothing more than the line problem. The bag proximity switch is damaged, and the controller is faulty, there are problems with the stepper motor driver. 5. During the operation, the packaging container is torn off by the powder automatic packaging machine. Once there is such a situation, the motor circuit problem should be checked to see if the proximity switch is damaged.