Since 2012 - Smart Weigh is committed to helping clients increase productivity at a reduced cost. Contact us Now!
Language
Since 2012 - Smart Weigh is committed to helping clients increase productivity at a reduced cost. Contact us Now!
Author: Smartweigh–Multihead Weighter
For the control box in weightless weighing, the installation is more critical. It should be installed on the foundation without the influence of switching power supply, or where the smoke and dust are relatively small, and it is convenient for the whole process to be observed during the work. It should be installed in the operating room and has a relatively good and reliable connection location. 1. The control panel of the system software in the weightless weighing scale should be installed in the electrical cabinet, and the electrical cabinet and the wiring on the spot, and the setting of the cable must contain the cable trench, the cable tray or the cable tray. The safety protection tube of the cable, in which the power cable and the data signal cable must be laid separately. 2. According to the relevant engineering drawings of the whole system software of the weightless weighing system, install and set it, ensure the good connection between the driving force line and the power line, and conduct a detailed inspection on it.
3. Although the electrical cabinet in the weightless weighing scale has been eliminated from the natural environment of dust, it must be removed on time, and the smoke and dust in the components of electrical equipment must be cleaned to ensure that the application of electrical components can be more secure. In the case of solving the components of electrical equipment or related safety accidents, it must be carried out by professional and technical personnel. 4. If the weightless scale does not need to be applied to the power switch of the soft starter, then the power switch of the electrical equipment can control the shutdown and start of the motor. The application of the vibrating feeder is the same. After the electrical equipment is disconnected , all dashboards will stop working immediately. 5. The gear box in the weightless scale should be replaced and replaced on time. In the case of changing the oil, it is necessary to ensure the quality and cleaning of the oil. If there is any residue, it will lead to poor equipment. harm.
6. When the weightless scale is in operation, there will be alarm conditions and conditions. At this moment, a purposeful inspection should be carried out to remove common faults. If the cable of the data signal or the cable of the driving force in the weightless scale is paved in parallel, then a certain distance should be ensured between each other to ensure that it is not easy to cause harm to each other, and the distance between the two should be ensured. Maintaining it at around 300mm is the key specification to ensure the normal application of the machinery and equipment.
Author: Smartweigh–Multihead Weighter Manufacturers
Author: Smartweigh–Linear Weighter
Author: Smartweigh–Linear Weigher Packing Machine
Author: Smartweigh–Multihead Weighter Packing Machine
Author: Smartweigh–Tray Denester
Author: Smartweigh–Clamshell Packing Machine
Author: Smartweigh–Combination Weighter
Author: Smartweigh–Doypack Packing Machine
Author: Smartweigh–Premade Bag Packing Machine
Author: Smartweigh–Rotary Packing Machine
Author: Smartweigh–Vertical Packaging Machine
Author: Smartweigh–VFFS Packing Machine
Copyright © Guangdong Smartweigh Packaging Machinery Co., Ltd. | All Rights Reserved
