Since 2012 - Smart Weigh is committed to helping clients increase productivity at a reduced cost. Contact us Now!
Language
Since 2012 - Smart Weigh is committed to helping clients increase productivity at a reduced cost. Contact us Now!
Author: Smartweigh–Multihead Weigher
The installation of the control cabinet in the multihead weigher is more important. For the purpose of the multihead weigher, it should be installed in a favorable position where there is basically no power interference, or the dust is relatively small, and it is convenient for observation of the working process. More importantly, it should be Install it in the control room with a relatively good and reliable grounding point. 1. The control instruments of the multihead weigher system should all be installed in the electric control cabinet, and the wiring of the electric control cabinet and the site, as well as the cable setting, must have wire trenches, cable bridges or cable protective tubes. The power cables and signal cables must be laid separately. 2. According to the relevant drawings of the whole multihead weigher system, install and set it up, ensure that the power lines and signal lines are well connected, and conduct detailed inspections.
3. Although the electric control cabinet in the multihead weigher is far away from the dusty environment, it still needs to be cleaned regularly to clean the dust in the electrical components to ensure that the use of electrical components can be more secure, while for electrical components When dealing with components or related accidents, it must be done by professionals. 4. If the multihead weigher does not need to use the switch of the frequency converter, then the electrical switch can control the stop and start of the motor. The same is true for the use of the feeder. After the electricity is disconnected, the entire instrument will stop working directly . 5. The gearbox in the multihead weigher needs to replace the lubricating oil regularly. When changing the oil, the quality and cleanliness of the oil must be guaranteed. If there are impurities, it will have a bad impact on the equipment.
6. When the multihead weigher starts to run, there will be alarming phenomena and situations. At this time, targeted investigation should be carried out to eliminate the fault. If the signal cable or power cable in the multihead weigher is laid in parallel, the multihead weigher calibration step should ensure a certain distance between the two to ensure that they will not affect each other before. The distance between the two should be kept at About 300mm, which is also the main standard to ensure the normal use of the equipment.
Author: Smartweigh–Multihead Weigher Manufacturers
Author: Smartweigh–Linear Weigher
Author: Smartweigh–Linear Weigher Packing Machine
Author: Smartweigh–Multihead Weigher Packing Machine
Author: Smartweigh–Tray Denester
Author: Smartweigh–Clamshell Packing Machine
Author: Smartweigh–Combination Weigher
Author: Smartweigh–Doypack Packing Machine
Author: Smartweigh–Premade Bag Packing Machine
Author: Smartweigh–Rotary Packing Machine
Author: Smartweigh–Vertical Packaging Machine
Author: Smartweigh–VFFS Packing Machine
Copyright © Guangdong Smartweigh Packaging Machinery Co., Ltd. | All Rights Reserved
