In the production process of an enterprise, regular maintenance of machinery and equipment is essential. The maintenance method of the automatic granule
packaging machine is quite special, and the parts need to be checked and adjusted. The maintenance process of the automatic granule packaging machine is as follows: 1. When the roller moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the proper position, adjust the gap so that the bearing does not make a noise, turn the pulley by hand, and the tension is appropriate. Too tight or too loose can cause damage to the machine. . 2. If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth canopy. 3. Regularly check the machine parts, once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other movable parts are flexible and worn. If any defects are found, they should be repaired in time and should not be used reluctantly. 4. After the automatic granule packaging machine is used or stopped, the rotating drum should be taken out for cleaning and the remaining powder in the hopper should be cleaned, and then installed, ready for the next use. 5. The automatic granule packaging machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
